Windows> 20
2. Click the Setting Printer icon. The Setting Printer dialog
appears.
3. Select “Manual”. In the Details section, you can now edit
the IP Address, Subnet Mask and Default Gateway
Address.
4. Click OK. The “Admin Password Required” dialog appears.
5. Enter the password. The default password is the last 6
digits of the MAC Address (upper case).
6. Click OK. Allow a few seconds for the changes to save and
the printer to automatically restart before the “Setup
Completed” message box appears.
C
HANGING
THE
A
DMIN
P
ASSWORD
To change the Admin Password for your printer:
1. Select Settings -> Change Password.
2. Enter the new password as requested.
3. Click OK. Allow a few seconds as the settings are saved
and the printer automatically restarts.
E
NABLE
/D
ISABLE
THE
P
RINTER
W
EB
P
AGE
To enable/disable access to the Printer Web Page from the
Network Card Setup utility:
1. Select Settings -> Setting Printer.
2. Select the “Printer Web Page” tab and select “Printer Web
Page - Disable” or “Printer Web Page - Disable”.
3. Click OK. The “Admin Password Required” dialog box
appears.
4. Enter the admin password as requested and click OK.
5. The “Setup Completed” message is displayed.
NOTE
If your printer stops at any time, you can restart it by
selecting Printer -> Restart Printer in the “Network Card
Setup pane”.
To Next Page
Loading...
