Network Configuration> 9
N
ETWORK
C
ARD
S
ETUP
UTILITY
The Network Card Setup utility allows you to carry out the
following:
> Set IP address, Subnet Mask and Gateway for TCP/IP
manually or by using DHCP.
> Launch the Printer Web Page.
> Enable/disable the Printer Settings Web Page.
> Restart your printer to ensure settings have been saved.
For full configuration options for your printer, access the Printer
Web Page. For information on the Printer Web Page, see “Using
a web browser” on page 9.
Support Configuration using the Network Card Setup utility
requires a PC with Windows 9x/Me, Windows 2000 Advanced
Server/Professional or Windows NT Server 4.0/Work-station 4.0
and Windows XP or a Mac with OS 9 or OS X. This utility can only
be used on a computer that can be connected to the network with
TCP/IP and located on the same segment as the printer.
To install and configure the Network Card Setup utility, see
> Windows: “Launching the Network Card Setup utility” on
page 18.
> Mac OS X: “Network Card Setup utility for Mac OS X” on
page 31.
> Mac OS 9: “Network Card Setup utility for Mac OS 9” on
page 28.
U
SING
A
WEB
BROWSER
If you do not wish to launch or install the Network Card Setup
utility, you can access the Printer Web Page directly through a
web browser.
If the printer is connected to the network using TCP/IP, its
settings and the printer menu settings can be configured using a
Web browser, such as, Microsoft Internet Explorer Version 5.5
and higher, Netscape Navigator version 6.2 and higher, Opera
6.0 and higher, or Safari 1.2 and higher. There is no guarantee
offered for other browsers. Refer to the relevant manuals for
details of how to launch and use the browser.
To Next Page
Loading...
Need help?
General
