Operator panel > 36
N
ETWORK
S
ETUP
This menu controls the operation of the printer’s network interface.
ITEM SETTINGS EXPLANATION
ENABLING DEFAULT
GATEWAY
WIRED
WIRELESS
(INFRASTRU
CTURE)
WIRED ENABLE
DISABLE
TCP/IP ENABLE
DISABLE
Enables or disables this network protocol.
NETBIOS OVER TCP ENABLE
DISABLE
Sets Enable/Disable of NetBIOS over TCP protocol.
Display Conditions: TCP/IP should be enabled.
IP ADDRESS SET AUTO
MANUAL
Specifies whether IP address allocation is automatic
(DHCP) or manually assigned.
IPV4 ADDRESS xxx.xxx.xxx.xxx Current assigned IP addres
s. To change,
press OK and
use MENU buttons to increment 1st octet, then press
OK again to move on to next octet. When 4th octet has
been set, press OK again to register new address.
SUBNET MASK xxx.xxx.xxx.xxx Current assigned subnet mask. To
change, proceed as
ab
ove.
GATEWAY ADDRESS xxx.xxx.xxx.xxx Current assigned gateway address. To ch
ange, proceed
as abo
ve.
DHCPV6 xxx.xxx.xxx.xxx
Current assigned DHCPV6. To change, proceed as above.
WEB ENABLE
DISABLE
Enables or disables Web config. facility.
TELNET ENABLE
DISABLE
Enables or disables Telnet config. facility.
FTP ENABLE
DISABLE
Enables or disables communication via FTP.
IPSEC ENABLE
DISABLE
Sets Enable/Disable of IPSec. Enable via the web.
ENABLE: IPSec is av
ailable.
DISABLE: IPSec is no
t available.
SNMP ENABLE
DISABLE
Enables or disables SNMP protocol.
NETWORK SCALE NORMAL
SMALL
Selects network size.
When NORMAL is selected, printer can work
effe
ctively, even when connected to a HUB that has a
spanning tree feature. However, printer start up time
gets longer when computers are connected with two or
three small LANs.
When SMALL i
s sel
ected, computers can cover from
two or three small LANs to a large LAN, but may not
work effectively when connected to a HUB that has a
spanning tree feature.
GIGABIT NETWORK ENABLE
DISABLE
Sets whether to enable access with Gi
gabit Ethernet.
To Next Page
Loading...
