Oki C332dnw - Wireless Setting

Operator panel > 51
W IRELESS S ETTING
If the Wireless LAN Module is fitted.
C332dnw comes with a Wireless LAN Module as standard, but the Wireless LAN Module is
set to Disable by default. To enable the Wireless LAN Module, refer to “Wireless LAN
Module” on page 65.
ITEM SETTINGS EXPLANATION
WIRELESS
(INFRA-
STRUCTURE)
SETTING
WIRELESS(INFRASTRUCTURE) ENABLE
DISABLE
Enables/disables the wireless LAN
(Infrastructure).
NETWORK
SETTING
IP ADDRESS SET AUTO
MANUAL
Select the IP address setting method.
IPV4 ADDRESS xxx.xxx.xxx.xxx Sets the IP Address.
SUBNET MASK xxx.xxx.xxx.xxx Sets the Subnet Mask.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx Sets the Gateway (default router) address.
DHCPV6 ENABLE
DISABLE
Sets enable/disable of DHCPv6.
WPS SETUP WPS-PBC Executes WPS-PBC.
WPS-PIN Executes WPS-PIN.
WIRELESS
SELECTION
xxxxxx Lists the detected wireless LAN (AP mode).
MANUAL
SETUP
SSID Input the SSID.
SECURITY DISABLE
WEP
WPA/WPA2-PSK
WPA2-PSK
Sets the security function of the wireless LAN.
WEP KEY Input WEP Key. 5-26 digits can be inputed.
WPA
ENCRYPTION
TYPE
AES
TKIP/AES
WPA2-PSK coding method.
WPA
PR
E-
SHARED
KEY
Input the Pre Shared Key.
EXECUTE Wireless reconnection
is executed.RECONNECTION