C3600n User’s Guide
63
Color menu
The printer automatically adjusts color balance and density at
appropriate intervals, optimizing the printed output for bright
white paper viewed in natural daylight conditions. The items
on this menu provide a means of changing the default settings
for special or particularly difficult print jobs. Settings revert to
their default values when the next print job is complete.
COLOR MENU
ITEM SETTINGS EXPLANATION
DENSITY
CONTROL
ADJUSTMENT
MODE
AUTO
MANUAL
If set to AUTO, image density will be
automatically adjusted at power on,
when a new image drum or toner
cartridge is installed, and at intervals
of 100, 300 and 500 drum counts. If
a 500 drum count interval occurs
during a print job it will occur at the
end of that job, and will take up to
55 seconds. If set to MANUAL, this
adjustment will only be performed
when initiated by the next menu
item.
CMYK
CONVERSION
ON
OFF
To simplify the conversion process of
CMYK data and reduce processing
time, set to OFF. Notes: This setting
is ignored when Ink Simulation is
used. This setting only applies to PS
models.
CMY 100%
DENSITY
DISABLE
ENABLE
When enabled, black areas are
produced using 100% C, M, and Y
instead of black. This results in a
glossier finish.
UCR LOW
MEDIUM
HIGH
Selects a limitation of the toner layer
thickness. If paper curling occurs in
dark printing, selecting MEDIUM or
LIGHT may reduce curling.
INK
SIMULATION
OFF
SWOP
EUROSCALE
JAPAN
Selects from a range of industry-
standard color swatches. Note: This
setting only applies to PS models.
DENSITY
ADJUSTMENT
EXECUTE Selecting this will perform the auto
density set up immediately.
To Next Page
Loading...
Need help?
General
