C3600n User’s Guide
88
6. Remove the protective sheets from the image drum unit. Keep it
the same way round as the old unit. Pack the old ID unit inside
the packaging material for disposal.
Toner_remove paper
7. Holding the complete assembly by its top center, lower it into
place in the printer, locating the pegs at each end into their slots
in the sides of the printer cavity.
ID_going in_Fig1_14.jpg
8. Finally, close the top cover and press down firmly at both sides so
that the cover latches closed.
NOTE
If you need to return or transport your printer for any reason,
please make sure you remove the image drum unit
beforehand and place in the bag provided. This is to avoid
toner spillage.
To Next Page
Loading...
Need help?
General
