- 100 -
Mac OS X Utilities
4
4. Using Utility Software
Mac OS X Utilities
This section explains utilities you can use in Mac OS X.
Panel Language Setup
You can change the operator panel display
language.
1 Output a menu map for the printer.
To output settings, press the <ENTER> button,
and select [Print Setup]>[Conguration].
2 Launch the panel language setup utility.
Reference
● “Installing Utilities” P.86
3 Select a method of connection.
When selecting [TCP/IP], enter an IP address.
You can check the IP address on the menu map
output in step 1.
4 Click [OK].
5 For the menu map “Language Format”
value, check that the value displayed
on the screen matches the following
conditions.
Condition 1:
The rst digit of the version
number matches.
Condition 2:
The value displayed on the screen
is the same as or newer (higher)
than the Language Format value.
Memo
● If Condition 1 is not met, an error will be displayed
in the operator panel when downloading. If Condition
1 is not met, an error will be displayed in the control
panel when downloading. In order to restore,
restart the printer. In case that Condition 1 is met
but Condition 2 is not met, though the printer can
be used, some setting names may be displayed in
English.
6 Select a language.
7 Click on [Download].
The language setting le will be sent to the
printer, and when sending is complete, a message
will be displayed.
8 Restart the printer.
Network Card Setup
You can use the Network Card Setup to
congure the network.
In order to use Network Card Setup, TCP/IP
needs to be activated.
Note
● Congure the TCP/IP settings.
Conguring the IP Address
1 Launch Network Card Setup.
Reference
● “Installing Utilities” P.86
2 Select the printer.
3 Select [IP Address...] from the
[Printer] menu.
4 Congure the settings if necessary and
click [Save].
5 Enter the password and click on [OK].
- The default password is the last 6
alphanumerical digits of the Mac address.
- The password is case sensitive.
6 Click on [OK] to activate the new
settings.
Restart the printer network card.