Oki C834DN User Manual

- 131 -
Changing Network Settings From the Web Page
5
5. Network Settings
Alert When Error Occurs
1 Perform steps 1 to 6 in “Periodic Alerts”
P.130.
When an error or warning requiring notication is
selected, a window will display to specify the time
between error occurrence and sending the alert.
2 Specify the time before sending error
alerts and then click [OK].
If you specify a longer time, you are only notied
of persisting errors.
3 Click [OK].
4 Click [View a Summary of Current
Conguration] to check the current
settings, and then click [X] to close the
window.
You can also check the current settings of up to
two addresses on the main window. Select the
desired addresses to check from the list box.
5 Click [Submit].
The network card reboots to enable the new
settings.
Controlling Access Using IP
Address (IP Filtering)
You can control access to the printer using
IP addresses. You can set whether to allow
conguration or printing from the IP addresses
specied. By factory default, IP ltering is
disabled.
Note
● Be sure to specify the correct IP address. If you specify a
wrong IP address, you cannot access the printer using the
IP protocol.
● When you enable IP ltering, access by hosts that are not
specied in these steps is rejected.
Memo
● You can use only IPv4 for IP ltering.
1 Access the printer’s web page and log in
as the administrator.
2 Select [Admin Setup].
3 Select [Network Setup]>
[Security]>[IP Filter].
4 Follow the on-screen instructions to
specify detailed settings.
Note
● If nothing is registered in [Administrator IP
Address that has been registered], you may
not be able to access the printer depending on the
specied IP address range.
● If you use a proxy server, [Your Current Local
Host/Proxy IP Address] and the IP address of
your host may not match.
5 Click [Submit].
The network card reboots to enable the new
settings.

Oki C834DN Specifications

General

Brand	Oki
Model	C834DN
Category	Printer
Language	English