- 27 -
Preparing Your Printer
1
1. Setup
4 Remove the metal plate (2) by sliding it
upward.
2
5 Make sure the LED (3) indicated by the
arrow turns off. If it is lit, wait until it
turns off.
3
6 Install the SD memory card (4) into the
SD memory card socket (5).
4
5
7 Install the SD memory socket to the
printer with the screw (6) and tab (7) for
the SD memory card socket and attach
the connector (8).
6
7
8
8 Install the metal plate (2).
2
9 Close the access cover (1).
1
10 Plug the AC cord and Ethernet or USB
cable into your printer, and then turn on
the power switch.
To Next Page
Loading...
