Oki Data CONFIDENTIAL
44043511TH Rev.2
139 /
5.1.2.2 Regular Self-Diagnosis Mode (Level 1)
The Regular Self-Diagnosis Mode menu is as follows.
• SWITCH SCAN
• MOTOR & CLUTCH TEST
• TEST PRINT
• REG ADJ TEST
• DENSITY ADJ TEST
• DENSITY CALIBRATION
• MEDIA WEIGHT ADJ PA
• FACTORY MODE SET
• SENSOR SETTING
• DRUM 1/N ROTATION
• CONSUMABLE STATUS
• PRINTER STATUS
• LED HEAD DATA
• GRAPHIC PANEL ADJUST
5.1.2.2.1 How to Enter Self-Diagnosis Mode (Level 1)
1. Press the [MENU+], [MENU-] and [HELP] keys at the same time when turning ON
the power to go to the System Maintenance Mode.
2. Press the [MENU+] and [MENU-] key until the “Diagnostic Mode” is displayed.
3. “Diagnostic Mode XX.XX.XX” appears on the LCD panel. The XX.XX.XX stands
for the version of the ROM. At the bottom right the setting of the “Factory Working
Mode” is displayed. This is usually “S-MODE”.
4. Press the [MENU+] or [MENU-] key to go to each self-diagnostic step. (The menu
item rotates by pressing the [MENU+] or [MENU-] keys)
DIAGNOSTIC MODE
XX.XX.XX S-MODE
To Next Page
Loading...
