Oki Data CONFIDENTIAL
44043511TH Rev.2
265 /
Function
LCD
Status Message Help Message
Shows printing from the printer’s MPT being
detected as having too much paper. Removing
excess paper from the tray removes this error. With
the removal of all the paper from the tray, the error
is removed and an error of being empty of paper in
the tray occurs. With the removal of part of paper
from the tray, the MPT is lifted and feeds paper.
Error 535: MPT
Remove Excess Paper
MPTray
Please see HELP for details
Error Code: 535
[Context]
Excessive paper volume on
MPTray.
[Action]
Take paper out of MPTray.
Reduce the amount of paper to
be loaded.
Load paper again.
Shows the stacker of the printer ran full.
Error 480: Face-down stacker
Error 484: Face-up stacker
Remove Paper
%STACKER%
Please see HELP for details
Error Code: nnn
[Context]
Excessive paper has accumulated
on the stacker.
[Action]
Remove paper accumulated in
the indicated stacker.
Shows the finisher stacker of the printer ran full.
Error 481: Stacker
Error 482: Fastening stacker
Error 483: Internal stacker
Remove Paper
%STACKER%
Please see HELP for details
Error Code: nnn
[Context]
Excessive paper has accumulated
on the finisher.
[Action]
Remove paper accumulated
in the indicated stacker of the
finisher.
The tray cassette of paper to which printing is
intended is removed, and paper cannot be fed.
Error 430 : Tray1
Error 431 : Ttay2
Error 432 : Tray3
Error 433 : Tray4
Error 434 : Tray5
Install Tray
%TRAY%
Please see HELP for details
Error Code: nnn
[Context]
A tray has not been inserted.
[Action]
Insert the indicated tray.
If the tray has been inserted,
pull it out and then reinsert it.
Indicates that message data to be updated is being
processed.
Wait a Moment
Message Data Processing
–
Indicates that message data to be updated is being
written.
Wait a Moment
Message Data Writing
–
Indicates that message data to be updated has
been written successfully.
Power Off/On
Message Data Received OK
–
Indicates that writing of message data to be
uploaded has been failed.
%CODE% is a decimal value (one digit) and
represents the cause of failure in writing.
= 1 … FAIL: Other errors.
= 2 … DATA_ERROR: Hash check error in data
reading/writing, or abnormal FLASH
= 3 … OVERFLOW: Downloading failure due to
FLASH memory full at starting or during
writing in a language file
= 4 … MEMORYFULL: Memory reservation failure
= 5 … UNSUPPORTED_DATA: Downloading data
unsupported on the printer
Check Data
Message Data Write
Error<%CODE%>
–
To Next Page
Loading...
