1
1-7 Setting up PostScript or PCL printing with Windows 98/Me
5. In the PS driver, to receive an e-mail notification after your job has been printed,
select Enable E-mail Notification, and type in the e-mail address to which notification
should be sent.
You will also receive e-mail notification of any errors that occur during printing.
NOTE: Enable E-mail Notification is displayed only if Email Service is enabled at Setup.
6. Click OK.
Completing the Windows 98/Me printer connection
To print from Windows 98/Me, you should already have set up network servers, if any,
and set up the Fiery to accept print jobs from your computer.
To complete the Windows 98/Me connection, you must configure a connection on
each Windows computer for the network.
Completing the Windows 98/Me parallel port connection
Preparing a parallel port connection for Windows 98/Me requires specific BIOS
settings on your computer, and specific port and printer settings for Windows 98/Me.
In addition, the administrator may need to change the parallel port timeout in Fiery
Setup if you choose to spool files to the Fiery, rather than print directly.
TO PREPARE THE FIERY AND YOUR COMPUTER
FOR PARALLEL PORT PRINTING
1. Connect the Fiery to the parallel port on your computer.
For instructions, see Chapter 1 of the Configuration Guide.
2. In Network Setup > Port Setup > Parallel Port Setup on the C9800 Control Panel, set
Enable Parallel Port to Yes.
For more information about Fiery Setup, see Chapter 4 of the Configuration Guide.
3. If you want to spool files to the Fiery, set Port Timeout in Seconds to 10.
If you want to print directly to the Fiery, set Port Timeout in Seconds to 5.
To Next Page
Loading...
Need help?
General
