- 32 -
Unpacking and Installing the Machine
1
2
4
5
6
3
4
Load paper in the paper tray.
(1) Open the paper tray.
(2) Adjust the paper stop and paper
guide to match the paper size.
Paper Guide
Plate
Paper Stop
Paper
Guide
Note
•
Squeeze the paper stop to adjust its position.
•
Do not remove the cork that is attached to the
plate.
(3) Flex the stack of paper back and
forth a few times. Then, make a
neat stack by straightening its
edges against a level surface.
Note
•
Using paper that is not recommended may
cause the machine to malfunction.
& For details about paper, see "Supported Paper"
(P.55).
(4) Load the paper with the side to
be printed on face down.
Set the direction
of the paper.
The side to be printed
on should be face down.
Mark
Note
•
Load the paper, making sure that it does not
exceed the mark on the paper guide. (530
pieces at 82g/m
2
)
(5) Set the paper size dial to match
the size of the paper.
Rotate the paper size dial until
it shows the size of paper
contained in the paper tray.
Paper Size Dial
(6) Close the paper tray.
To Next Page
Loading...
Need help?
General
