- 5 -
1
2
4
5
6
3
When installing or moving
For the U.S.A. and Canada
Multifunctional Digital Systems require 110 to 127 V, 8 A, 50/60 Hz electric power.
For the EU
Multifunctional Digital Systems require 220 to 240 V AC, 4 A, 50/60 Hz electric power.
Except the U.S.A., Canada and the EU
Multifunctional Digital Systems require 220 to 240 V AC, 4 A, 50/60 Hz electric power.
•
Do not use a power supply with a voltage other than that specied.
Avoid multiple connections in the same outlet. This could cause a re or give you an electric shock. If
you are considering increasing the number of outlets, contact an electrician.
•
Always connect this machine to an outlet with a ground connection to avoid the danger of re or
electric shock in case of short-circuiting. Contact your service representative for the details. Be sure
to use a 3-conductor, grounded wall outlet.
In areas, except the U.S. and Canada, where a 2-pin plug is used, the machine must be grounded for
safety. Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
•
Plug the power cord securely into the outlet. If it is not plugged in properly, it could heat up and
cause a re or give you an electric shock.
•
Do not damage, break or attempt to repair the power cord.
The following things should not be done to the power cord.
-
Twisting it
-
Bending it
-
Pulling it
-
Placing anything on it
-
Heating
-
Situating it near radiators or other heat sources
This could cause a re or give you an electric shock. If the power cord is damaged, contact your
dealer.
•
The socket outlet shall be near the equipment and be easily accessible.
•
Pull out the plug from the outlet more than once a year to clean around the prongs. Accumulating
dust and dirt could cause a re due to the heat released by electric leakage.
To Next Page
Loading...
Need help?
General
