Oki ML620 - Page 65

ML620/ML621 User’s Guide 65
MENU SETTINGS TABLE
Group Item Function Settings (defaults are set in bold italic)
Serial I/F
(cont.)
Baud Rate Set this to match your system’s
transmission speed.
19200 bps, 9600 bps, 4800 bps,
2400 bps, 1200 bps, 600 bps, 300
bps
DSR Signal Used with the Ready/Busy
protocol (factory default) to select
the way your system handles the
DSR signal.
Valid, Invalid
DTR Signal Change to Ready on Select if the
DTR signal is required when the
printer is selected (leave as Ready
on Power Up if the DTR signal
is required when the printer is
turned on).
Ready on Power Up, Ready on
Select
Busy Time Sets the length of the busy signal
when the Ready/Busy protocol
(factory default) is engaged,
0.2 sec, 1 sec
Stop Bit Set the stop bit length. 1 bit, 2 bit
Receive Error When “checked” is selected the
printer checks for the correct
number of bits and sends an error
if an incorrect number is found.
Checked, Unchecked