Oki ML620 - Page 68

ML620/ML621 User’s Guide 68
MENU SETTINGS TABLE
Group Item Function Settings (defaults are set in bold italic)
Extension
(cont.)
Right Margin (Cut Sheet) If the printer data exceeds the
width of the paper, printing is
truncated column-by-column.
Specify a margin from the right
edge of the paper.
Right Margin Over, .0394” (1 mm),
.0787” (2 mm), .12” (3 mm), .16”
(4 mm), .2” (5 mm), .24” (6 mm)
Table Footnotes:
1 Selects both double-width and double-height character or
single-width and single-height characters.
2 When “1 line” ID selected, the receiving buffer size is set
to 8K bytes.
3 When “Limited Operation” is selected, after exiting MENU,
only.
4 Displayed only for ML621.
5 With Form Tear Off function “on,” if the printer is idle for
a few moments (approximately 0.5, 1, or 2 seconds), the
paper is forward advanced, from the current position,
to the tear bar position. If more data is received and
processed by the printer, the paper is then automatically
reversed feed back to the original printing position.
6 Displayed only when the roll paper stand (RPS) is
connected.
7 Displayed only for ML emulation.
8 Displayed only for IBM emulation.
9 Displayed only for EPSON emulation.
10 Displayed only for serial I/F board mounting.
11 Appears only if the optional Cut Sheet Feeder is installed.