Oki ML620 - Page 67

ML620/ML621 User’s Guide 67
MENU SETTINGS TABLE
Group Item Function Settings (defaults are set in bold italic)
CSF (Cut
Sheet
Feeder) Bin
1
(cont.)
Cut Sheet Top of Form Specify an adjustment value for
the reference position for the
TOF position when feeding a cut
sheet (up to the mid-section of
characters in the rst line).
1/12” (2.12 mm), 2/12” (4.23 mm),
3/12” (6.35 mm), 4/12” (8.47 mm),
5/12” (10.58 mm), 6/12” (12.70
mm), 7/12” (14.82 mm), 8/12”
(16.93 mm), 9/12” (19.05 mm),
10/12” (21.17 mm), 11/12” (23.28
mm), 12/12” (25.40 mm), 13/12”
(27.52 mm), User Top of Form
LF Revise Adjust the line feed in cut sheet
mode.
–14 ~ –1, 0, +1 ~ +14
Centering Position Used to limit printhead travel
when printing narrow columns.
Select Mode 1 for ML620. Select
Mode 1 or Mode 2 for the ML621.
Default, Mode1, Mode2
Extension
Detect Sprocket Hole For continuous paper set to be
fed via the individual Form paper
route: the default is to have the
printer detect sprocket holes; to
turn detection off, set to disable.
Enable, Disable
Right Margin (Continuous
paper)
If the printer data exceeds the
width of the paper, printing is
truncated column-by-column.
Specify a margin from the right
edge of the paper.
Right Margin Over, .0394” (1 mm),
.12” (3 mm), .2” (5.08 mm), .39”
(10 mm), .51” (13 mm), .59” (15
mm), .79” (20 mm), .98” (25 mm)