Connecting to the PC after preparing the device
- 54 -
2
Press the scroll button ▼ on the operator panel several times to select [Admin Setup], and
press «OK».
3
Input the admin password using the numeric keypad, and press «OK».
4
Check that [Network Setup] is selected, and press «OK».
5
Check that [Basic Settings] is selected, and press «OK».
6
Check that [Extended Network] is selected, and press «OK».
7
Press ▼ to select [Wireless], and press «OK».
8
When [Are You Sure?] is displayed, check that [Yes] is selected, and press «OK».
9
Wait until the standby screen appears as this machine restarts.
2. Enabling the AP mode
1
Press the scroll button ▼ on the operator panel several times to select [Wireless(AP Mode)
Setting], and press «OK».
2
Input the admin password using the numeric keypad, and press «OK».
To Next Page
Loading...
