Connecting to the PC after preparing the device
- 55 -
3
Check that [Wireless(AP Mode)] is selected, and press «OK».
"Cannot be used simultaneously with wireless(infrastructure)." will be displayed for about 5 seconds.
4
Press ▲ to select [Enable], and press «OK».
After setting Wireless(Infrastructure) to [Disable], if a screen appears to ask you to check whether to enable
wireless (AP mode), press «OK» to enable wireless (AP mode).
5
Press «ON LINE» to return to the standby screen.
3. Connecting with a device
There are two ways as follows.
Connecting automatically(Push button)
Connecting manually
Connecting automatically (Push button)
If the wireless terminal supports WPS-PBC (push button), you can connect it to this machine using the WPS
button.
1
Check the position of the WPS button in the User's Manual enclosed with the wireless terminal.
2
Press the scroll button ▼ on the operator panel several times to select [Wireless(AP Mode)
Setting], and press «OK».
3
Input the admin password using the numeric keypad, and press «OK».
"Cannot be used simultaneously with wireless(infrastructure)." will be displayed for about 5 seconds.
To Next Page
Loading...
