10044 Planer OLIVERMACHINERY.NET 15 | Page
Setup
Shop Preparation
Space Requirement
The dimensions of this machine are 33-3/16”(L) x 23-
1/4”(W). You will need additional spaces for
manipulating your workpiece, electrical connection,
and dust collection.
Electricals
If you plan to install this machine in a permanent
location, make sure a properly sized circuit and
electrical outlet are available nearby. Please refer to
section “Electricals” in this manual for details
regarding electrical requirements.
Lighting
Adequate lighting is needed for operating this machine. Overhead, non-glare lighting should be installed.
Safety Labels
If this machine introduces a new safety hazard to your workplace, display proper warning signs in a highly
visible location(s).
Dust Collection
Wood dust created by this planer is a health hazard. Position this planer in a spot where it has access to a
dust collection system.
Dust masks should be available for using the planer.
CAUTION
Use a dust collection system that is rated above
300 CFM. Doing so imp
roves air
quality in the workplace, and
prevents the machine from jamming.
Piping of dust collection system introduces additional air resistance and decreases
the effective CFM measured at the dust ports. Ensure
there is significant suction at
dust and debris can be effectively removed from the machine.
To Next Page
Loading...
