Oliver 10044 - Troubleshooting

10044 Planer OLIVERMACHINERY.NET 37 | Page
Troubleshooting
Problem
Possible Cause
Possible Solution
Machine does not
start.
Machine is not
connected to a
power source.
1. Make sure the machine is plugged in.
2. Check the electrical panel for a tripped circuit
breaker or a blown fuse.
3. Ensure all electrical connections have good
contacts.
Low voltage /
current.
1. If an extension cord is used, use a
shorter/heavier extension cord.
2. Have an electrician to check/repair the power
circuit.
Worn motor
brushes.
Replace motor brushes.
Faulty switch/motor.
Contact customer service for further assistance.
Machine trips thermal
protection / circuit
breaker, or blow fuses.
Machine is
undersized for the
operation.
Reduce the depth of cut.
Workpiece moisture
level is too high.
Only plane wood with moisture level below 20%.
Machine is jammed.
Inspect the cutterhead and make sure it is not
obstructed by woodchips. Check dust hood and
clear blockages.
Too much load on a
circuit.
Make sure the power circuit is sized for this
machine. If the circuit is shared, ensure it is sized to
supply power for all items in the circuit.
Motor issue.
Contact customer service for further assistance.
Machine stalls during
operation.
Machine is
undersized for the
operation.
Reduce the depth of cut.
Dull cutters.
Rotate/replace cutter inserts.
Belt slipping.
Clean belt and pulleys. Replace belt as needed.
Motor issue.
Contact customer service for further assistance.
Machine stopped
during operation.
Overload protection
triggered.
Hit the OFF button and allow the machine to cool
down for at least 3 minutes, then press the
overload protection reset button. Reduce the
depth of cut before continue.
Digital readout not
functional.
Dead battery.
Replace the battery (AAA type).
Frozen display
Remove batteries. Wait for 1 minute and reinstall
the batteries.