Settings (cont.)
XY Origin Position represents your picture and how it will be oriented on your work piece. (However this will
ultimately be determined when you set the spindle to your preferred starting point on the work piece, but this
will be discussed later in section 7.)
If using a single piece of material for one carving it may be advantageous to start in the center as this is an
easy point to find on your material. However, if carving several objects on one piece of material it might make
sense to start in one of the corners in order to ‘nest’ the projects.
a. Center
b. Upper Left
c. Upper Right
d. Lower Left
e. Lower Right
Preview allows you to preview your project before saving:
Preview
To Next Page
Loading...
