Network Configuration> 30
IP A
DDRESS
S
ETUP
If you only use TCP/IP and the printer has not yet been
configured, occasionally it may not be displayed on
AdminManager. You can configure the IP address of the printer
by this function.
1. Select [IP Address Setup] from the [Setup] menu.
2. Set [Ethernet Address] and [IP Address] and select [OK].
> The Ethernet Address (MAC address) is displayed during
the self-diagnostic test.
3. AdminManager asks if you want to initialise the network
interface card or not. Select [Yes].
To Next Page
Loading...
Need help?
General