Network Configuration> 9
U
SING
Q
UICK
S
ETUP
Quick Setup utility allows you to configure the network interface
easily and simply without installing any software packages.
You can configure the following:
> Enable/disable TCP/IP, NetWare, EtherTalk, NetBEUI
protocols.
> Set IP address, Subnet Mask and Gateway for TCP/IP
manually or by using DHCP.
> Set NetWare mode and create Queue/Print Server/Printer
objects.
> Zone name and Port name for EtherTalk.
Configuration requires a PC with Windows 2000 Advanced
Server/Professional or Windows XP running TCP/IP or IPX/SPX
(NetWare).
This utility can only be used on a PC that can be connected to the
network with TCP/IP or IPX/SPX.
This utility must be used on a PC that is located on the same
segment as the printer.
To create a NetWare queue, NetWare Client 32 or IntranetWare
Client should be installed in your system.
The following explanation uses Windows 98 as an example.
Telnet Configure the NIC using
TELNET.
Third-party vendor
developed TELNET
client package.
A TELNET Application is
standard in Windows/
UNIX/Linux.
SNMP The printer and network
card can be controlled
using third-party
vendor developed SNMP
application.
Third-party vendor
developed SNMP
application.
UTILITY FEATURES SYSTEM
REQUIREMENTS
To Next Page
Loading...
Need help?
General