Microsoft Windows> 56
Now that both Windows and the printer have been configured to
use TCP/IP, the next step is to configure Windows to print to the
network printer.
W
INDOWS
2000
NOTE:
Windows 2000 requires administrator privileges.
With Windows 2000, there are four options for printing using
TCP/IP.
> Manufacturers’ LPR
> Microsoft LPR
> Port 9100
> IPP
Manufacturers’ LPR
Please follow the procedure described on page 50.
Microsoft LPR
NOTE:
In order to use Microsoft LPR, it must first be installed on your
system.
To install this port, proceed as follows:
1. Select [Start], [Settings], [Control Panel and Printers].
2. Open the [Printers] folder.
3. Double-click [Add Printer] and then select [Next].
4. Select [Local Printer], clear the [Automatically detect my
printer] check box, and then select [Next].
5. Select [Create a new port] and then [LPR Port].
6. Select [Next] and then provide the following information:
(a) In [Name or address of server providing LPD] enter
the host name or Internet Protocol (IP) address of
the host for the printer you are adding.
(b) In [Name of printer or print queue on that server]
type "lp".
To Next Page
Loading...
Need help?
General