Microsoft Windows> 55
The Ethernet address of the printer can be found on the
self-diagnostic printout, which can be printed by pressing
the push-button on the network card panel for three
seconds and then releasing it.
Using TCP/IP protocol
When using lpr in UNIX and other TCP/IP environments,
please select [Yes]. To use in a TCP/IP environment, an IP
address should be assigned to the Ethernet card.
If [Yes] has been selected and TCP/IP is the only working
protocol and the IP address has not already been assigned,
you can either obtain an IP address automatically or assign
an IP address.
When [Obtain an IP address automatically] is selected, the
device IP address will be automatically assigned by the
DHCP server. In an environment without a DHCP server,
please assign the IP address manually.
If you are assigning an IP address, you need to enter:
• An IP address
• Subnet mask
• Gateway address.
8. Click [Next].
Using NetWare protocol
Consult your network manager to ensure that the NetWare
file server is properly installed and working on the network.
Make sure that NetWare Client32 or IntranetWare Client is
installed on your computer.
On selecting [Yes] you will be asked if [You set-up the
queue from the Wizard]?
Using EtherTalk protocol
EtherTalk is the required protocol for printing data from the
Macintosh environment.
Using NetBEUI protocol
Using NetBEUI makes it easy to manage your Oki product
and print within the network environment of Windows.
9. Confirm your configuration. If everything is correct, click
[Execute] to apply the configuration.
10. Set-up has now been completed. Click [Finish].
To Next Page
Loading...
Need help?
General