UNIX> 76
HP-UX 10.
X
CONFIGURATION
The following example uses HP-UX10.20 and a C7300V2 printer
as examples. The absolute path and method of configuring
commands may differ in other versions of the OS. Refer to the
workstation manual for more details.
1. Confirm that the IP address of the printer has been set.
See network interface card IP address configuration for
more information.
2. Login as [root] to the workstation. If you do not have
superuser rights, the network manager should conduct
the configuration.
3. Register the IP Address of the network card and the host
name in the /etc/hosts file.
Example: for IP Address 192.168.20.127 and host name
c7350
192.168.20.127 c7350
4. Use the ping command to confirm connection with the
network card.
Example: for host name c7350
# ping c7350
If there is no reply, there is a problem with the
configuration of the IP address (the IP address has already
been set manually or dynamically), or with the network.
Reset the network interface card settings to default and try
to set a temporary IP address. If you still have the problem
after resetting the network interface card, consult the
network manager.
CAUTION!
If an incorrect IP Address, Subnet Mask or Gateway is
entered, the network may go down or other damage
may occur. Check the address with the network
manager.
To Next Page
Loading...
Need help?
General