Network Configuration> 51
10. When the installation ends, the [Setup complete] screen
is displayed. Check [Yes, I want to launch the LPR Utility
now] and click [Finish]. Check [Yes, I want to view the
ReadMe File] if you want to read [Readme]. The LPR
utility starts.
11. You may be asked whether it is OK to change write
permissions for the spool directory. Click [Yes] to allow
the utility to be correctly installed.
12. Select [Add Printer] on the [Remote Print] menu.
13. Click [Discover…] to search for the IP address of a suitable
printer on your network.
14. Highlight the printer you will use and click [OK].
15. If your printer is not discovered, click [Cancel] and you
can type the IP address directly at [IP Address:].
16. Enter an IP address at [IP Address] and click [OK]. A
printer is added to the main window.
Refer to the On-line Help for information on how to use the utility.
U
NINSTALLATION
1. Stop the LPR Utility.
2. Select [Start]-[All Programs].
3. Click [Yes] when the [Confirm File Deletion] dialogue is
displayed. Deletion of the LPR utility starts.
4. When the deletion has finished, the [Uninstall Complete]
screen is displayed. Click [OK].
If a file that has been added after installation exists in the folder
to install the LPR utility or the folder to spool, you cannot delete
the folder. Delete any unwanted files before running [Uninstall
LPR Utility].
To Next Page
Loading...
Need help?
General