51
6. Press the keys
until the display shows:
TEL.LINE SETUP
SILENCE LAPSE
7. Press the key:
The display shows:
SILENCE LAPSE
6 SECS
8. To view the other available values, "SILENCE LAPSE
- 3 SECS", "SILENCE LAPSE - 4 SECS", "SILENCE
LAPSE - 8 SECS", "SILENCE LAPSE - 10 SECS" or
"SILENCE LAPSE - NO", press the keys:
If you select "SILENCE LAPSE - NO", the fax machine
will not interrupt the recording in any case.
9. To confirm your choice, press the key:
10. To return the fax machine to its initial stand-by mode,
press the key:
11. If you want to move back one function, press the key:
Note
If you connect an external telephone answering device,
make sure that the silence lapse on the fax machine is less
than the one set on the answering device.
TO CHANGE THE REMOTE CONTROL CODE
If the fax machine is connected to an extension that
operates in tone dialling mode and is set up for manual
reception, whenever there is a call from a corre-
spondent wishing to send you a document, you can set
it to receive the document by typing the code * * on the
extension. This operation has the same effect as press-
ing the
key on the fax machine.
You can replace the second "asterisk" of this code us-
ing digits from 0 to 9.
1. Press the key:
The display shows:
MENU
RECEPT. SET-UP
2. Press the keys
until the display shows:
MENU
INSTALLATION
3. Press the key:
The display shows:
INSTALLATION
STATION NAME
4. Press the keys
until the display shows:
INSTALLATION
TEL.LINE SETUP
5. Press the key:
The display shows:
TEL.LINE SETUP
LINE TYPE
6. Press the keys
until the display shows:
TEL.LINE SETUP
REMOTE CONTROL
7. Press the key:
The display shows:
REMOTE CONTROL
YES
8. Press the key:
The display shows the code you set previously, for
example:
SET ACCESS CODE
(0-9,*) *8
9. To type the new code, press the keys:
-
10. To confirm the new code, press the key:
11. To return the fax machine to its initial stand-by mode,
press the key:
12. If you want to move back one function, press the key:
NOTE
If you want to disable this function, after step 7, press the
keys to display "REMOTE CONTROL - NO", then press the
key to confirm and the key to return the fax ma-
chine to its initial stand-by mode.
To Next Page
Loading...
