Olivetti M15 Plus - Page 34

GETTING STARTED
You are working on batteries. The hard disk is switched
on. Hard disk switch (18,8) in the ON position (=1);
however, you switched the hard disk on after the power
switch (22,A) has been switched on.
We recommend as a matter of routine that you follow the
autodiagnostics (message: HDU ready) when you are planning
to use your hard disk to make sure that the hard disk is
available.
SWITCHING ON - BATTERY POWER - SYSTEMS WITH TWO
DISK DRIVES
This does not require any
power
ON switch (22,A)
working.
special attention. Switch the
into the ON position and start
SWITCHING ON - BATTERY POWER - SYSTEMS WITH
HARD DISK
Some attention is required:
If you are planning to use the hard disk:
1. With the power ON/OFF switch (17) in the OFF
position (=0) switch the hard disk switch (18,8)
into the ON position (=1).
2. Switch the power switch (22,A) into the ON position
and start working.
If you are NOT planning to use the hard disk (for
example to save battery power):
1. With the power ON/OFF switch (17) in the OFF
position (=0) switch the hard disk switch (18,8) to
the OFF position (=0).
3-7