Olivetti M15 Plus - Page 35

2. Switch the power switch (22,A) to the ON position
and start working.
NOTE 1:
Before switching orr your hard disk (for example to save
battery power) while you are in a work session proceed as
follows (when operating on batteries):
1. Save your current work session.
2. Switch off your system (power switch (22,A) into the
OFF position (=0) ).
3. Switch the hard disk OFF.
4. Switch the system on
autodiagnostics.
again and observe the
3- 8
M15 PLUS INSTALLATION AND OPERATIONS GUIDE