Olivetti M15 Plus - Page 36

GETTING STARTED
NOTE 2:
Before
switching ON your hard disk while you are in a work
session proceed as follows (when operating on batteries):
1. Save your current work session.
2. Switch off your system (power switch (22,A) into the
Off position (=0) ).
3. Switch ON the hard disk.
4. Switch the system on again and watch the
autodiagnostics.
IMPORTANT: The syste. will not recognize the hard disk when
it is switched on after the syste8 has been switched on
(when working on
batteries).
SWITCHING orr - SYSTEMS WITH TWO DISK
DRIVES
Save the current work session and switch the system off.
No special attention is required.
SWITCHING orr - SYSTEMS WITH HARD
DISK
Before you switch off or transport the system, an important
step is required in order to protect the hard disk heads.
We recommend you read Chapter 8 which provides all
information required on this subject.
3-9