Olivetti M15 Plus - Page 82

Select the option you want. If you have selected the
option for performing a single module test, a list of
modules and system components to be tested will be
displayed. Select the module you want to test. When the
test of the module is finished, press ENTER to continue
testing the next module. If you have selected the
automatic test, each module is tested in sequence.
During the test of a specific module (both in SYSTEM
CHECKOUT or TEST ONE MODULE mode), the module name and a
graphic representation of the module are displayed. The
percentage of time that remains to complete the test
appears in a rectangle on the screen.
A message will appear asking you to wait for the test to be
completed. At the completion of the test, a message will
appear stating that the test has passed or failed.
When the diskette drive(s) is (are) tested, a message will
ask you to remove the CUSTOMER TEST diskette and insert a
formatted diskette as described above.
IMPORTANT: When the diskette drive test(s) is (are)
finished, you will need to re-format the diskette(s) if you
want to use it (them) for anything else.
You will find the CUSTOMER TEST program easy to use. The
messages which appear during the test will guide you
through the program. You need not worry about making wrong
selections.
If you find a malfunction which cannot be so lved with the
recommendations in the table above, then call your Field
Service Representative for assistance. You can explain the
problem and the results of the CUSTOMER TEST .
Whenever you wish to change diskettes during the
Test, .ake sure that the diskette in the drive is
accessed. Look at the access indicator light for
concerned and ensure that it is not lit.
Custa.er
not being
the drive
8-6 M15 PLUS INSTALLATION AND OPERATIONS GUIDE