Olympus BH-2 Series - Reinstall the Guide Rails into the Focus Block; Reinstall the Guide Rails into the Guide Block; Figure 30 - Guide Rails Installed into the Arm Casting; Figure 31 - Reinstall Short Guide Rails into the Focus Block


CompleteTeardown,Cleaning,andReassemblyoftheOlympusBH‐2SlidingFocusBlock  Revision2 Page13of23 


Figure30–Guiderailsinstalledintothearmcasting
ReinstalltheGuideRailsintotheFocusBlock
Per the procedure described in Appendix 1of this
document,reinstalltwooftheshortguiderailsinto the
side groove in the focus block  (see Figure 31) and
remove any exposed grease from the two guide rails
(seeFigure32andFigure33).

Figure31–Reinstallshortguiderailsintothefocusblock

Figure32–Scrubgreasefromguiderailsandfocusblock

Figure33–Guiderailsinstalledintothefocusblock
ReinstalltheGuideRailsintotheGuideBlock
Per the procedure described in Appendix 1 of this
document, reinstall thetworemaining shortguide rails
into the side groove in the guide block (see Figure 34)
and remove any exposed grease from the two guide
rails(seeFigure35andFigure36).

Figure34–Reinstallshortguiderailsintotheguideblock

Figure35–Scrubgreasefromguiderailsandguideblock