Olympus BH-2 Series - Set the Guide Rails into the Greased Guide; Clean Grease after Reinstalling the Guide Rails; Figure 64 - Apply Grease to both Ends of the Guide Block; Figure 65 - Place First Guide Rail into the Guide Block


CompleteTeardown,Cleaning,andReassemblyoftheOlympusBH‐2SlidingFocusBlock  Revision2 Page21of23 

Figure64–Applygreasetobothendsoftheguideblock
SettheGuideRailsintotheGreasedGuide
Place one of the guide rails into  one of the ins ide
cornersofthesidegrooveoftheguideblock(seeFigure
65)and press the guide rail down firmly at the endsto
thoroughlyembeditintothegrease(seeFigure66).

Figure65–Placefirstguiderailintotheguideblock

Figure66–Setthefirstguiderailintothegrease
Placethesecond guide railintothe other inside corner
ofthesidegrooveoftheguideblock(seeFigure67)and
press the  guide rail down firmly at the ends to
thoroughlyembeditintothegrease(seeFigure68).

Figure67–Placesecondguiderailintotheguideblock

Figure68–Setthesecondguiderailintothegrease
CleanGreaseafterReinstallingtheGuideRails
Aftertheguiderailshavebothbeenplacedinthe guide
block and pressed down firmly into the grease, any
visible traces of the grease should then be removed
from the guide block and guide rails.The best way to
do this is to use dry cotton swabs to scrub the
 grease
away(seeFigure69).

Figure69–Scrubanyvisiblegreasefromtheguiderails
Thefreshgreaseshould comeoffeasily with drycotton
swabs.Donotuseanysolventhere,asthesolventmay
run under the guide  rails and foul  the grease holding
theminplace.Carefullyworkfromtheinsideoutwhen 