Playback on a TV
Playback
6
113
1
Make sure that the TV and camera are turned off. Connect the
A/V OUT jack on the camera to the video input terminal on
the TV using the AV cable provided with the camera.
2 Turn the TV on, and set it to the video input mode.
• For details of switching to video input, refer to your TV’s instruction manual.
3 Turn the camera on.
• The last picture taken is displayed on the TV. Use the arrow pad to select
the picture you want to display.
You can select [NTSC] or [PAL] according to your TV’s video signal type. Use this
setting when playing back pictures on a TV in a foreign country. Select the [VIDEO
OUT] signal before connecting the AV cable. If you select the wrong video signal
type, you will not be able to play back the recorded pictures properly on the TV.
TIPS
• You are recommended to use the optional AC adapter when playing back
pictures on a TV.
• The close-up playback, index display and slideshow functions can also be used
on a TV screen.
Note
• Make sure that the camera’s video output signal is the same as the TV’s video
signal. g“Video output selection” (P. 113)
• The camera’s monitor turns off automatically when the AV cable is connected
to the camera.
• Be sure to use the AV cable provided to connect the camera to the TV.
• The picture may appear off-center on the TV screen.
Video output selection
Connect to the TV’s video input
(yellow) and audio input (white)
terminals.
AV cable
A/V OUT jack (MONO)
To Next Page
Loading...
