Remote control shooting (optional)
5
Additional functions
95
You can select the time from when the shutter button on the remote control is
pressed until the picture is taken.
AUTO The picture is taken immediately when the shutter button on the remote
control is pressed.
3SEC The picture is taken approximately 3 seconds after the shutter button
on the remote control is pressed.
1 Press the Z button, then press Z.
• When [OFF] or [Y] is set, the menu cannot be displayed by pressing Z.
2 Select [AUTO] or [3SEC], and
press Z.
Note
• If the remote control receiver is exposed to strong light, the effective signal
distance may be reduced or shooting may not take place.
• To shoot sequential shots using the remote control, press and hold the shutter
button on the remote control. If the camera does not receive the remote control
signal properly, sequential shooting may stop.
• To view pictures using the remote control, refer to the instruction manual for the
remote control.
Changing the time until remote control is activated
Mode dial
AUTO
3
SEC
GO
OK
SELECT
To Next Page
Loading...
