Selecting the flash
55
Basic shooting functions
3
Basic shooting functions
This setting is for when using a commercially available slave flash that is
synchronized with the camera flash.The amount of light emitted by the flash can be
adjusted in 10 levels. The flash can fire in sequential shooting mode, but the interval
between shots will be longer if a high emission level is set.
AUTO, ! : The setting is automatically changed to [#] (Fill-in flash).
H SLOW : The setting is automatically changed to [#SLOW1].
1 Press the # button, then press Z.
g“Direct buttons” (P. 16)
2
From [
Q
FLASH], select
[SLAVE],
and press d.
3 Select an emission level from [1]
to [10], then press Z.
Note
• The camera’s flash mode will have no effect on the external flash. The external
flash will fire even when the camera’s flash mode is set to [$] (off).
• Confirm in advance that the external flash you are using is synchronized with
the camera.
Using a slave flash mode
Mode dial
SLAVE
FLASH MODE
FLASH
SLOW
SELECT GO
OK
IN+
5
SLAVE FLASH
GO
OK
SELECT
To Next Page
Loading...
