Pixel mapping
132
7
Settings
Top menu [MODE MENU] [SETUP] [FILE NAME] [RESET] / [AUTO]
g“Menus” (P. 23)
The pixel mapping feature allows the camera to check and adjust the CCD
and image processing functions. It is not necessary to operate this function
frequently. Approximately once a year is recommended. Wait at least one
minute after taking or viewing pictures to allow for proper performance of
the pixel mapping function.
Top menu [MODE MENU] [SETUP] [PIXEL MAPPING]
g“Menus” (P. 23)
1 When [START] is displayed,
press Z.
• The [BUSY] bar is displayed during pixel
mapping. When pixel mapping is
finished, the screen returns to the mode
menu.
Note
• When the File No. reaches 9999, the file number returns to 0001 and the folder
number changes.
• When both the Folder and File No. reach their respective maximum number
(999/9999), the number of storable pictures becomes 0 even if the card is not
full. No more pictures can be taken. Replace the card with a new one.
Note
• If you turn the camera off during pixel mapping, start again from Step 1.
Mode dial
Pixel mapping
Mode dial
FILE NAME
PIXEL MAPPING
m/ft
AF ILLUMINATOR
DUAL CONTROL PANEL
START
PIC
CARD
SETUP
CAM
To Next Page
Loading...
