201
Chapter 11
Troubleshooting (Cont.)
POSSIBLE CAUSES CORRECTIVE ACTION
REF. PAGE
No picture is taken when the shutter button is pressed.
1 The mode dial is set to
.
2 The memory gauge is
full.
3 The flash has not
finished charging.
4 The card access lamp
blinks during recording
in the mode.
5 There is a problem with
the card.
6 The card is full.
7 The batteries ran out of
power.
8 The monitor indications
disappear, or only the
battery check lights up.
9 A write-protect
adhesive seal is placed
on the card or there is
no card in the camera
(Smart Media).
1 Set the mode dial to any
position except .
2 Wait until there is room in
the memory gauge.
3 Remove your finger from the
shutter button and wait until
the orange lamp stops
blinking. Take your shot
again.
4 The recorded movie image
data is being written to the
card.You can start shooting
again when the card access
lamp stops blinking.
5 See the error code chart.
6 Erase unwanted pictures or
insert a new card. Before
erasing, download important
images to a PC.
7 Replace the batteries with
new ones.
8 Replace the batteries with
new ones. (Do not open the
battery compartment cover
when the card access lamp
is blinking.)
9 Insert a new card in the
camera.
P. 5 2
P. 1 6
P. 8 3
P. 7 5
P. 208
P. 2 5
P. 2 0
P. 2 0
P. 2 5
To Next Page
Loading...
