Olympus CLV-U20 - Connection to AC Mains Supply

1_5_-_2_C_o_n_n_ec_ti_·o_n_f_o_A_e C __ . M_az_·n_s_eS_eu_'P_'P_ly ~ ~):===========
CD Make sure the power switch is in the off position.
v
"
m
~
"
:to;
is
z
"o
"
c
en
m
The converter adapter from three pin plug
to two pin plug cannot be safely grounded
and electrical shock may
Do not connect the power cord for the light
source to the outlet for TC-V1.
@ The power-cord plug must be connected to a grounded hospital grade outlet or a wall rna-Ins
outlet 13-cord outletl.
* Do not use converter adapter from three pin power plug to two pin power plug for
safety precautions.
* Connect the light source directly to hospital grade receptable or wall mains outlet
without connecting to table tap for safety.
* Firmly set power cord during inspection. Do not apply excess force to power cord by
bending, pulling, twisting and pressing.
* When combined with TC-V1 (compact video trolley), do not connect the power cord
of light source to the secondary outlet of TC-V1 to prevent malfunction due to the
subsequent power voltage lowering. Be sure to connect the power cord directly to
hospital grade receptacle.
* Refer also to the instruction manuals for combined instruments being used.
@ Connect the power cord properly to the "HOSPITAL GRADE" receptacle or the wall mains
outlet that meets the input requirements indicated on the ratings plate on the rear panel
of
the light source.
[Shock prevention]
Ratings plate
~-J®
Power plug ~
Hospital grade receptacle
{wall mains outlet)
Always connect the power cord
properly to the "HOSPITAL
GRADE" receptacle or the wall
mains outlet.
Power switch should be in the "OFF"
position.