8
1_8_-1_C_a_~_e_a_ifi_te_r_U_s_e
::::======================:J
Cleaning
the
light
source
I·
8-2 Storage
Put
on
the
vinyl
cover.
CD
Disconnect the endoscope
and
water container
from
the light source. Unplug
the
power
cord
from
the hospital grade receptacle (wall mains outlet),
* Do
not
apply
excess
force
when
disconnecting
the
light
guide
connector
from
the
output
socket.
@ Lightly wipe
all
surfaces using a soft cloth or gauze sponge. If dirt persists, moisten the
gauze with disinfectant ethanol
and
wipe
again.
The front panel can be also disinfected.
@ For disinfection, wipe
with
a gauze sponge moistened
with
disinfectant ethanol or
2%
glutaraldehyde solution.
*
Avoid
touching
the
electrical contacts and connectors:
poor
contact
will
result.
*
To
prevent
scratches,
do
not
use
hard
or
abrasive
wiping
material.
*
If
a
glutaraldehyde
solution
is used,
wipe
again
with
disinfectant
ethanol
to
remove
all residue.
* Surfaces
must
be
thoroughy
dry
before use,
CD
Wind the
power
cord around
the
hangers on the rear
of
the light source.
@ Place the light source on a stable surface
in
the horizontal position.
* Do
not
store
in
the
upright
position,
as
it
may
topple.
® Put on the vinyl dust cover.
"*
Storage area
must
be
maintained
at
normal
temperature
and
humidity,
and
away
from
water
splashes.
"*
Do
not
apply
excessive force
to
each cord
by
bending,
pUlling,
twisting
and
pressing
irrationally.
* Do
not
give
heavy
blows
and impacts.
good
forconneetor
parts}
Do
not
wet
the
output
socket.
!JlJ
"ijJ I
°0
;~,
Do
not
put
in
the
upright
position.
Avoid
high
temperature,
high
humidity
and
direct
sunligh.
Do
not
strike
or
drop.
n
»
:xl
m
»
z
o
if)
-1
o
:xl
»
G)
m
To Next Page
Loading...