Olympus CLV-U20 - After Use

7-4 Cinematography and ccrv
D
Set to AUTO
Set the AUTO/MANUAL Brightness Selector to AUTO.
[Cinematography]
* When using MC-R44 or MC-R58, set brightness control switch to "Manual" to adjust
it to appropriate brightness level.
* The index numbers are standard setting. Adjust index depending on conditions.
[CCTV]
* To prevent thermal mucosal damage as well as to protect your eyes, set the AUTO/
MANUAL Brightness Selector to MANUAL before disconnecting the cine camera or
TV camera from the fiberscope, because the light path shutter fully opens (providing
maximum brightness) as soon as the camera is disconnected.
* Always connect the light control cable IMB-608), when using the OTV-S2. When
using OTV-F or OTV-S, refer to their instruction manuals before operation.
For visual observation, set the Mode Selector to ~ .
fJ Adjuistingi Briglhtnes;s (CIIIIE AIIiD
Light source
Filming
Fiberscope
Adapter
CINE. TV
Development
speed
Film
Index
A1O-Cl
24
Ips i
Daylight
OES Al0-C2
3 Standard
ISO/ASA 160
AlO-C3
Rigid
!
MC-R44
Standard
24
Ips I
Daylight
scope
I 0 ES type
MC-R58
-
ISO/ASA 160
Camera
I
Fiberscope
.. [Adapter I
Index
OTV-F2
OES Fiberscope
i ~ .... ~ ..!
3
r1R-T2 i
OTV-S2
Rigid scope
,AR-TF2 I
3
D Still Phot,ograp,hy
!Selection of Observation
Mode]
[Brightness control] \-J
u.J
U
'"
::J
o
(f)
l-
I
(!J
::J
u.J
I
I-
(!J
Z
~
'"
u.J
a..
o
7·SAfter Use
Turn off the Power Switch.
* Disconnect the power cord from the AC wall outlet if the light source is not going to
be used for a long period.