Connecting recorder to PC
Connecting to your PC using the USB cable
1 Boot the PC.
2 Connect the USB cable to the USB port of the PC.
3 Connect the USB cable to the connecting terminal on the
bottom of the recorder.
• [ Remote (Composite) ] is displayed on the recorder if the USB cable is
connected.
Once you connect the recorder to your PC, the recorder will be powered
through the USB cable.
While PC connection, the SD card is recognized as the respective
removable disk drive.
4
EN
56
Notes
• NEVER remove the card or disconnect the USB cable while the record
indicator light is fl ashing. If you do, the data will be destroyed.
• Some PC’s may not supply suffi cient power and the recorder fails to
connect. Refer to your PC user’s manual regarding the USB port on your
PC.
• Do not connect the recorder to a PC by using a USB hub. Make sure to
connect to a USB port on your PC.
• Make sure to push the cable connector all the way in. Otherwise, the
recorder may not operate properly.
Connecting recorder to PC
To Next Page
Loading...
