130
EN
12
Information
If the optimum exposure cannot be obtained when pressing the shutter button halfway, the
display will blink in the viewfinder and on the super control panel.
* The aperture value at the moment when its indication blinks varies with the lens type and
focal length of the lens.
Exposure warning display
Shooting
mode
Warning display
example (blinking)
Status Action
P
The subject is too dark. • Increase the ISO sensitivity.
• Use the flash.
The subject is too bright. • Decrease the ISO sensitivity.
• Use a commercially available
ND filter (for adjusting the
amount of light).
A
The subject is underexposured. • Decrease the aperture value.
• Increase the ISO sensitivity.
The subject is overexposured. • Increase the aperture value.
• Decrease the ISO sensitivity or
use a commercially available
ND filter (for adjusting the
amount of light).
S
The subject is underexposured. • Set the shutter speed slower.
• Increase the ISO sensitivity.
The subject is overexposured. • Set the shutter speed faster.
• Decrease the ISO sensitivity or
use a commercially available
ND filter (for adjusting the
amount of light).
s0030_e_00_0_unified.book 130 ページ ２００９年７月３日 金曜日 午後４時１１分
To Next Page
Loading...
