Olympus GX53 - Turning on the Main Switch

16
3-2 Turning ON the main switch
When using the reflected LED light source (BX3M-LEDR)
Set the main switch
a
to
(ON).
When using the light source other than the reflected LED
light source (BX3M-LEDR)
Set the main switch of each unit to (ON).
Combinable units Unit to set to ON
Mercury burner
Main switch of the power supply for
mercury burner (U-RFL-T)*
Halogen bulb
Main switch of the power supply for
halogen bulb (TH4-100/TH4-200)
Light source
Power supply switch of the LED and
LDP light source (U-LGPS)
1
1
* When using the mercury burner, the arc image becomes stable 5
to 10 minutes after turning it ON.
The discharge type mercury burner may not be turned ON
in one operation due to its nature. In this case, set the main
switch to
(OFF) once, wait 5 to 10 seconds and set it to
(ON) again.
· Do not turn OFF the mercury burner for two hours after
turning it ON in order to prevent the burner from reducing
its lifetime.
· When turning ON the mercury burner again, wait until
the vapor of the mercury burner is cooled down and
devolatilized. Wait approx. 10 minutes and turn it ON.
When using the control box (BX53M-CBFM)
Set the main switch to (ON).
The buzzer sound is heard once.
TIP
NOTE
1
TIP
a