132
Chapter 6 Measurement procedures
Stereo optical adapter selection
1 The stereo optical adapter list shown below is displayed when the
live screen is displayed if a stereo optical adapter is attached.
This list shows all the set numbers and adapter names of the stereo optical
adapters registered that are the same type as the stereo optical adapter that is
connected. The line selected in the list is the stereo optical adapter that was
used the last time that measurements were made.
2 Select the optical adapter to be used from this list and press the
[MEAS/ENTER] joystick.
• If a stereo optical adapter that is the same type as the stereo optical adapter
that is connected has not been registered, you need to register the stereo
optical adapter by executing “NEW STEREO ADAPTER”. See “Using a new
stereo optical adapter (NEW STEREO ADAPTER)” (page 134) for details
about operations.
• Select “CANCEL” and press the [MEAS/ENTER] joystick to end the stereo
optical adapter settings and return to the live screen. The stereo optical
adapter list is displayed until the stereo optical adapter is removed.
To Next Page
Loading...
