45
Chapter 3 Preparation and inspection before observation
Inspecting/replacing the safety cap (IV8635X1 only)
Inspecting the safety cap
CAUTION
• If the safety cap cannot be attached securely to the end without the hook of the provided
hook assembly or if there is any other irregularities such as break of the strap, replace the
safety cap with the spare. The safety cap can be replaced with the procedure on the following
page.
1 Make sure that the strap of the safety cap is attached to the
universal cable. Make sure that the strap is free of irregularities.
2 Make sure that the safety cap is attached securely to the end of the
hook assembly.
Strap
To Next Page
Loading...
