62
Chapter 4 Basic operations
Checking the LCD monitor image
1 Open the shade of the LCD monitor and ensure that the LCD
monitor displays the observation image.
2 Make sure there are no dark patches or dirt in the image. If you find
any irregularities, go back to “3.5 Inspecting the scope” (page 39)
and “3.7 Inspecting the optical adapter” (page 51) to check it again.
NOTE
• The screen displays and menu operations are enabled approximately 40 seconds after the
[POWER] button is pressed.
• When the language setting is changed, the time taken until the screen display functions, such
as menu selection, may be longer than before. This is not a malfunction.
• When using the stereo optical adapter, the positions of the left and right images may not line
up either horizontally or vertically depending on the combination of optical adapter and
scope. However this is not a malfunction.
• The displayed title is the title that was entered on the Live screen the last time the system
was used.
Indicator display
Freeze indicator
Temperature
indicator
LogoSequence
number
Recording/playback indicator
Brightness/contrast
level
Gain mode
Zoom level
Date/time Title
Battery indicator
Hi-Beam
indicator
Optical adapter name
Note
Recording
destination
indicator
To Next Page
Loading...
