Using Software Options
Part # 910-250C
129
Note: Surface preparation is almost always required for proper coupling.
The measurement is accomplished when you move two cursors individually along the
waveform. The software then calculates the time (distance/thickness) between these two
measurement points, along with the dB difference between them. The waveform can
either be frozen or live during the measurement. In addition, the software is valid in any
rectified mode including RF mode.
9.12.1 Activating the Wave Analysis Software
The Wave Analysis software is enabled in the EPOCH 4PLUS through the Option
Security key, similar to the other software options.
To activate the Wave Analysis software, follow these steps:
1. Press [OPTION].
2. Press [] or [], and [ENTER] to select the Wave Analysis option.
Figure 80 Selecting Wave Analysis from the Options Menu
3. Select On.
4. Press [OPTION] to exit the menu and return to the live screen.
Note: Wave Analysis is not valid with other software options in the EPOCH
4PLUS such as DAC, TVG, and Interface Gate.
When Wave Analysis is active, the gates on the display disappear and are replaced with
Cursor A and Cursor B as shown in the figure below.
To Next Page
Loading...
